qertclever.blogg.se

1. #Dockmate controller install
2. #Dockmate controller driver

By pressing the right button (starboard) the stern thruster gives thrust to the left so the stern is moving to the right. By pressing the right button (starboard) the bow thruster gives thrust to the left so the bow is moving to the right.īy pressing the left button (port) the stern thruster gives thrust to the right so the stern is moving to the left.

#Dockmate controller driver

NOTE: With the Gearbox, driver installed it has no effect – Dockmate is always active then.īy pressing the left button (port) the bow thruster gives thrust to the right so the bow is moving to the left. Pressing this button makes the Dockmate the active steering position. NOTE: When this button is pressed other signals are inhibited for safety, so the boat controls go to neutral, regardless of the position of the joystick. Press 3 times quickly or hold for 3s to shut it off. Press and hold to turn the transmitter on. When pressed together, you can choose between windlass 1 and 2 (2 or 4 beeps) if the Dockmate Receiver is fitted with the AnchorX2 module. By pressing the lower button, you raise the anchor. Indicates no communication, low battery, warning or error.īy pressing the upper button you lower the anchor. It also shows if any special options have been activated through Dockmate. It also shows warnings and errors if there are any. Shows the status of the connection with the Receiver. The transmitter has the following features : We recommend that you always wear the lanyard around your neck while using the DOCKMATE. (accessible by screwdriver?) Use of the DOCKMATE Please note that one-time settings are needed at the Receiver.

#Dockmate controller install

Install the Receiver free of vibrations.Install the Receiver in a dry, not too warm area.These have already been paired so they recognize each other. Our system consists of two major components: a transmitter and a Receiver. The installation has to be done by a qualified engineer. The transmitter and receiver may only be opened by an authorized technician.Please note that when the system is in operation each involuntary push on the buttons of the transmitter has an action as a result.Batteries should be charged as soon as the orange LED signal on the transmitter lights.Remember that the use of the DOCKMATE from ashore or the jetty is a criminal offense in several countries. Never use the DOCKMATE if you are not on the ship.In very exceptional circumstances, the communication between the transmitter and receiver can be disturbed by radio frequency transmitters in the immediate neighborhood.Make sure you can operate the DOCKMATE like an expert before actually using it in a crowded harbor.Contact your DOCKMATE dealer when any abnormality is detected. Test both devices before use with the boat in a safe environment. Do not use the DOCKMATE when the transmitter or receiver have been immersed in water.Keep it away from small children (choking hazard). The DOCKMATE may only be used by persons who have the necessary skills of maneuvering a yacht.Beware for suffocation by plastic packaging. The devices contain small parts which can be swallowed by children. Leuvensesteenweg 177 – BE-3191 Boortmeerbeek – Belgium This may cause an explosion or fire.ĭockmate is a registered trademark from PPA-Electronics B.V. Do not use near flammable gases or liquids.

Repairs may only be performed by licensed technicians.

Touching the internal parts may lead to injuries.